Monday, February 22, 2010

Tracking Area Update (TAU) Procedure Initiation

The UE in state EMM-REGISTERED shall initiate the tracking area updating procedure by sending a TRACKING AREA UPDATE REQUEST (TAU) message to the MME,

a) when the UE detects entering a tracking area that is not in the list of tracking areas that the UE previously registered in the MME;

b) when the periodic tracking area updating timer T3412 expires;

c) when the UE enters EMM-REGISTERED.NORMAL-SERVICE and the UE's TIN indicates "P-TMSI";

d) when the UE performs an inter-system change from S101 mode to S1 mode and has no user data pending;

e) when the UE receives an indication from the lower layers that the RRC connection was released with cause "load balancing TAU required";

f) when the UE deactivated EPS bearer context(s) locally while in EMM-REGISTERED.NO-CELL-AVAILABLE, and then returns to EMM-REGISTERED.NORMAL-SERVICE;

g) when the UE changes the UE network capability information or the MS network capability information or both;

h) when the UE changes the UE specific DRX parameter;

i) when the UE receives an indication of "RRC Connection failure" from the lower layers and has no user uplink data pending;

j) when the UE enters S1 mode after 1xCS fallback;

k) when due to manual CSG selection the UE has selected a CSG cell whose CSG identity is not included in the UE's Allowed CSG list;

l) when the UE reselects an E-UTRAN cell while it was in GPRS READY state or PMM-CONNECTED mode;

m) when the UE supports SRVCC to GERAN or UTRAN and changes the mobile station classmark 2 or the supported codecs, or the UE supports SRVCC to GERAN and changes the mobile station classmark 3; or

n) when the UE changes the radio capability of at least one of the following radio access technologies: GERAN, UTRAN or cdma2000®.

For all cases except case b, the UE shall set the EPS update type IE to "TA updating". For case b, the UE shall set the EPS update type IE to "periodic updating".

For case n, the UE shall include a UE radio capability information update needed IE in the TRACKING AREA UPDATE REQUEST message.

2 comments:

Adarsh said...
This comment has been removed by the author.
Adarsh said...

Hi,
I have a one doubt.Please spare some time.

I have a TAU in the Initial_UE_Message(Initial_Ue_Message->NAS_PDU->TAU->OldGUTI).
The Old_GUTI value is 450/050/0011/11/1231(MCC/MNC/LAC/RAC/PTMSI).

The spec (23.401-b21, 4.3.19) says

MME Side:
"if the GUMMEI is mapped from PTMSI/RAI then the MSB is 0 and if GUMMEI is native then MSB is 1"

SGSN Side:
"If MSB of the LAC is 1 then the PTMSI/RAI is mapped from the GUTI else PTMSI is Native"


Now my doubt is " should i set the MSB of LAC to "1" ?

Yes, after the Initial_Ue_Message, MME Sends the Identity Request to the SGSN.

--Thanks,
Jayateerth